Liben Indoor Playground Meets ASTM Standard

Date: 2016.03.23 Views: 4358

Liben is a professional manufacturer of indoor playground equipment in China. We are very committed to designing and manufacturing indoor playgrounds that comply with the International Safety Standards.

Liben indoor playgrounds are designed and manufactured in compliance with world’s most comprehensive safety standards that are specifically developed for ‘Soft Contained Play Equipment’. By complying with these standards, we can minimize the injury hazards in the indoor playground and to make sure that it will pass safety inspections in your country. Below are the standards that we follow:

Indoor Playground of ASTM Standard-1

6.2.1 Accessible Openings - A completely bounced rigid opening is accessible when it is possible to insert the torso test probe into the opening to a depth of 4.0 in. (100mm) or more.

6.2.2 Nonrigid Completely Bounded Openings - A nonrigid opening such as may be found in but not limited to flexible torso probe will penetrate the opening to a depth of 4.0 in. (100mm) or more when tested in accordance with the test procedure outlined in 6.2.2.1 (See Figs. A1.1 and A1.2 for probe dimensions).
6.2.3 Angular Portions Openings - Angled formed by the surface of an opening (that is, adjacent surfaces or surfaces that intersect when projected with a distance between surfaces greater than 9.0 in. (230mm)) should be at least 55°unless one of the conditions defined in 6.2.3.1 exists.

Indoor Playground of ASTM Standard-2

Straight Slides

· Flat open chutes should have slides at least 4 inches high extending along both sides of the chute for the entire length of the inclined sliding surface.

· Slides may have an open chute with a circular, semicircular or curved cross section

provided that:

A. The vertical height of the slide is no less than 4 inches when measured at right angles to a horizontal line that is 8 inches long when the slide is intended for Toddlers, 12 inches long when the slide is intended for preschool-age-children, and 16 inches long when the slide intended for school-age-children;

B. For any age group, the vertical height of the slides is no less than 4 inches minus two times the width of the slide chute divided by the radius of the slide chute curvature.

Indoor Playground of ASTM Standard-3

Chute Exit Region

All slides should have an exit region to help children maintain their balance and facilitate a smooth transition from sitting to standing when exiting. The chute exit region should:

· Be between 0 and -4°as measured from a plane parallel to the ground.

· Have edges that are rounded or curved to prevent lacerations or other injuries that could result from impact with a sharp or straight edge.

· For toddlers the chute exit region should:

- Be between 7 and 10 inches long if any portion of the chute exceeds a 24°

Slope.

- Be no more than 6 inches above the protective surfacing.

- Have a transition from the sliding portion to the exit region with a radius of

curvature of at least 18 inches.

· For preschool and school-age the chute exit region should:

- Be at least 11 inches long.

- Be no more than 11 inches above the protective surfacing if the slide is no

greater than 4 feet high.

- Be at least 7 inches but no more than 15 inches above the protective surfacing

if the slide is 4 feet high.

Prev:ASTM Standard of Indoor Trampoline Park Next:Biggest trampoline park in Europe set to open in Wolverhampton as two new sites are planned

Liben Indoor Playground Meets ASTM Standard

Global Franchise Opportunities

Build Your Park Now